FEATURES

Interface-to-Echo Mode

In interface-to-echo mode, the gauge can take readings on thicker plastics and other materials between 1.65mm and 25.4mm (0.065" to 1")

Echo-to-Echo Mode

Measurements can be taken on materials as thin as 0.15mm (0.006 inches). In echo-to-echo mode, the user can take measurements on pre-coated materials without having to remove the coating prior to measurement i.e. the gauge ignores the coating thickness.

High Speed Scan Mode

Identifies the minimum thickness point over a large area by moving the transducer over the surface. While the transducer is in contact with the material being measured the smallest value is held in memory and displayed when scanning is complete.

PLAS* Mode

Specifically for use when measuring thin plastics. Please note that to use this mode, a special Graphite Delay Line must be purchased, Part Number T92016871.

Differential Mode

Displays the positive or negative difference between a pre-set nominal (target) thickness value and the actual measured value.

Alarm Mode

Allows the user to set a target so that an audible and visual alarm operates when taking measurements. If the measurement falls below a pre-set nominal (target) value a red LED will light and the bleeper sounds. A green LED will light to indicate an acceptable thickness.

Data Output

Allows the user to send data direct to a printer or PC.

Data-Logging

A storage capacity of 1000 measurements – 10 files consisting of 100 sequential storage locations. Allows the user to send data direct to a printer or PC.

EDTS⁺ Excel link Software

PC data transfer utility including generator of ASCII files and “data drop” add in for Microsoft Excel™ spreadsheets.

EDCS⁺ Software

Stand alone data management program with advance facilities for archiving, reporting, analysis and data export.